Top Menu

Shop

Sale!

RODE VideoMic Pro

$299.00 $253.00

Brand: RODE
SKU: VideoMicPro
  • Compact, Lightweight Design
  • Integrated shock mounting
  • All-new capsule with lower noise and higher sensitivity
  • Broadcast recording quality condenser microphone
  • Powered by 9V Battery
  • Integrated foam windscreen
  • 3.5mm stereo mini-jack output
  • Two step High Pass Filter (flat, 80Hz)
  • Three position level control (-10dB, 0, +20dB)
  • Camera shoe mount with 3/8” thread for easy boom pole mounting

Overview

Video Mic Pro is sure to take your production quality to the next level. It is designed for use with camcorders, DSLR cameras, and portable audio recorders. All-new 1/2″ condenser capsule that provides broadcast quality audio via a 3.5mm minijack connector with a low self-noise of just 14db.

Proven Rycote Lyre Shock Mount

Also updated is the Rycote Lyre anti-noise, anti-shock mount which dramatically reduces unwanted handling noise caused by physical knocks and bumps during recording. Made from a hard-wearing thermoplastic material, the Lyre system will never wear out, sag or snap, providing superior longevity compared to elastic suspension style shock mounts.

Level Control

Easily accessible on the rear face of the mic are the power switch and a 3-setting level control that provides a neutral, -10dB and impressive +20dB boost delivering better results for your specific shooting environment.

Battery

The VideoMic Pro is battery powered and provides over 70 hours recording from a single 9V battery.

Specification

Acoustic Principle   Line Gradient
Active Electronics   JFET impedance converter
Capsule   0.50″
Address Type   End
Frequency Range   40Hz – 20kHz (selected HPF @80)
Output Impedance   200Ω
Maximum SPL   134dBSPL
Maximum Output Level   6.9mV (@ 1kHz, 1% THD into 1KΩ load)
Sensitivity   -32.0dB re 1 Volt/Pascal (20.00mV @ 94 dB SPL) +/- 2 dB @ 1kHz
Equivalent Noise Level (A-weighted)   14dBA
Weight   85g
Dimensions   100mmH x 75mmW x 170mmD

Enquire about 'RODE VideoMic Pro'

  • This field is for validation purposes and should be left unchanged.

Related Products